← Back to Analog Atlas

Analog Atlas · Field method

From satellite screening to ground truth.

Concept · the rover is not built yet

Satellites see a whole planet, but only from above. A rover sees one place, but up close. Our method uses both: the atlas finds Earth places that match a Moon or Mars target, and a low-cost rover goes there, measures the ground itself and calibrates the satellite data.

The method in 4 steps

STEP 1

Target profile

What the Moon or Mars site is like: temperature, slope, rock type and resources, from NASA orbiter and rover data (LRO, MRO, MGS, PDS).

Live in the app
STEP 2

Earth screening

Analog Atlas scores 19 Earth sites and all of Jordan (886 boxes of 10 km) against each target, with every value sourced.

Live in the app
STEP 3

Field calibration

The rover visits the best candidates and measures rock, soil, local climate and slope, each reading tagged with position and time.

Concept
STEP 4

Explained score

The score is updated with the field data. Each pillar shows its match, its source and how sure we are, so an engineer sees where the analog works and where it fails.

Concept

Steps 1 and 2 are the app you can open today. Steps 3 and 4 are the next phase.

Why a rover

What orbit cannot see

  • Pixels of 10 m to 1 km mix rock, sand and shadow.
  • Dust and air blur the surface signal.
  • No view under the soil, or inside lava caves.

What the rover adds

  • Rock spectrum from 5 cm away.
  • Soil moisture, salt and pH under the surface.
  • Slope and roughness of the last metres, where a lander or rover actually moves.

The rover

A 60 cm, six-wheel rover with a rocker-bogie suspension, the design that has driven on Mars since Sojourner (1997), then Spirit, Opportunity, Curiosity and Perseverance. We keep the proven design and change the job: instead of exploring another planet, it measures Earth analog sites cheaply, with off-the-shelf parts.

PartMeasuresFeeds pillar
AS7265xReflectance in 18 bands, 410–940 nm, from 5 cm: the mineral fingerprint of the rockGeology
RS485 soil probeSoil moisture, temperature, salinity (EC) and pH under the surfaceResources
BME280Air pressure, temperature and humidityClimate
SCD41 · O₂ sensorCO₂ and oxygen near the groundClimate (context)
TFmini Plus LiDAR + MPU-6050 IMUDistance and tilt while driving: the local surface Z = f(X, Y), slope and roughnessTerrain
GPS modulePosition and time for every reading (to add)All
ESP32Reads all sensors (I²C, UART, RS485) and sends the data packet—

Open the interactive rover blueprint (3D model, wiring, data pipeline; Arabic/English) → Concept, illustrative numbers.

How the data travels

Sensors→ESP32 packet (value, unit, position, time)→SD card log + upload to the server→Analog Atlas score

Every value carries its unit, source and type: measured on site, derived from a map, or not available. The same rule as the app: nothing is invented.

How we use AI

Now: calibration

Pairs of field readings and the satellite pixel over the same spot teach a model how much the satellite value differs from the ground. The corrected values then improve the score for every site of the same type.

Later: reverse inference

With enough pairs, the model can work the other way: from orbital data alone, it ranks Moon and Mars areas that no rover has visited, with an uncertainty for each, to suggest where missions look first. A ranking, not a fact.

Working with satellites and CubeSats

The rover does not replace orbiters or CubeSats. Satellites give the wide map; the rover is a ground-truth point that checks it. One field day can calibrate a whole scene of a satellite image over a similar terrain.

Sensor alternatives
Limits